FUJITSU C2330 - Manual (Page 6)

6
L i f e B o o k C S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA
devices are installed. *Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylinders,
heads and sectors may also be displayed.
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options Default Description
Type: • Auto
• None
• CD-ROM
• Hard Disk [Auto] Selects the ATA/ATAPI device type. Select Auto to have the type
automatically identified by the BIOS at POST. If None is selected, all
of the following Set-up items do not appear. Select CD-ROM if a
CD-ROM drive is installed at this connection. If Hard Disk is
selected, you must specify the number of Cylinders, Heads, and Sec-
tors for the drive.
CHS Format (Cylinders, Heads, Sectors)
Cylinders: • A number
between 0 and
65,535
–— This appears only when Hard Disk is selected. When Hard Disk is
selected, you can change the value. This field is incremented by
pressing the [Spacebar]). This field is decremented by pressing the [-
] key. You can also change the field by typing in the number.
Heads: • A number
between
1 and 16
–— This appears only when Hard Disk is selected. When it is selected,
you can change the value. This field is incremented by pressing the
[Spacebar]). This field is decremented by pressing the [-] key. The
field can also be changed by typing in the number.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Primary Master [FUJITSU MHT2040AT-(PM)]
Type: [ Auto ]
LBA Format
Total Sectors: 78140160
Maximum Capacity: 40008MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
PIO Transfer Mode: [Multiword DMA 2]
DMA Transfer Mode: [Disabled]
▲