Cd/external disc control features, English – Kenwood KDC-5070R User Manual
Page 20
This function permits the connection of optional players and
the playing of discs other than the loaded CD (in the current
unit).
Playing Discs:
Press the SRC button repeatedly to select the external disc
control mode.
The disc will start playing.
The external disc control mode will differ, depending on the unit
that is connected.
Mode Display Examples
• "CD2"...when a CD player is connected
• "DISC"...when a disc changer is connected
• "DISC-1", "DISC-2"...when two disc changers are connected
Pausing and Restarting Disc Play:
Press the
38 button to make the disc pause.
Press the same button again to start play again.
NOTE
NOTE
Playing Other Disc mode
• The unit can only play 12-cm (5-inch) CDs. If you insert an 8-cm
(3-inch) CD, it will get stuck inside and can cause the unit to
malfunction.
• When the faceplate has been dropped open, it might interfere
with the shift lever or something else. If this happens, pay
attention to safety and move the shift lever or take an
appropriate action, then operate the unit.
• Do not apply excessive force to the open faceplate or place
objects on it. Doing so will cause damage or breakdown.
• Do not use the unit with the faceplate in the open condition.
Doing so will cause breakdown.
When you load a CD and eject it right away, the next time you try
to insert the CD may not load. In such a situation, take the CD out
for a moment and then reinsert it.
NOTE
Playing CDs:
A press of the release button causes the faceplate to drop to
the front, thereby exposing the CD slot.
Holding the CD with the labeled side facing up, insert it in the
slot. The CD will start playing. Push back on the right side of
the faceplate with your hand until it locks.
The ¢ indicator will light when a CD has been inserted.
When inserting a CD, make sure the CD has been completely
drawn in before pushing back the faceplate. Failing to do so might
scratch the CD.
Playing CDs Already Inserted:
Press the SRC button repeatedly until the CD mode is obtained.
"CD" is displayed when the CD mode has been selected.
The CD will start playing.
Pausing and Restarting CD Play:
Press the
38 button to make the disc pause.
Press the same button again to start play again.
Eject:
Press the release button and drop open the faceplate.
Press the
0 button located near the CD slot.
The CD stops playing and ejects from the slot.
Push back on the right side of the faceplate with your hand until
it locks.
• Do not attempt to insert a CD into the slot if another one is
already there.
2CAUTION
0
2CAUTION
Playing CDs
CD/External disc control features
— 20 —
English