Fisher & Paykel CG122 - Manual (Page 29)

27
Care and cleaning
Burners and grates
You can remove and clean these parts with hot soapy water or other appropriate products - see
‘Cleaning chart’.
After cleaning, check that the burners and their flame spreaders are dry before replacing
correctly.
It is very important to check that the burner flame spreader and the cap have been correctly
positioned. Failure to do so can cause serious problems.
Note: to avoid damage to the electronic ignition, do not try to light a burner without all burner
parts correctly in place.
Replacing the burners
Check that the ignitor (Figs. 28 and 29) is always clean to ensure trouble-free sparking.
Check that the probe (Figs. 28 and 29) next to each burner is always clean to ensure correct
operation of the safety valves.
Both the ignitor and probe must be very carefully cleaned using a toothbrush and rubbing
alcohol (Fig.25).
Cap
Fig. 28a Correct line-up of auxiliary, rapid
and semi-rapid burner parts
Ignitor
Flame
spreader
Fig. 28b Replacing the auxiliary,
rapid and semi-rapid burner cap
Flame failure probe
US CA