Falcon Graphics RJ-6000 Series - Manual (Page 15)

An appropriate location for installing the printer should be selected after refer-
ring to the following conditions for the installation site and installation space.
• Always use a separate, earthed power outlet.
• Avoid places subject to sudden change of temperature or
humidity, dust, or the direct rays of the sun.
• The RJ-6000 Series printer should not be in the direct draft
from an air conditioner.
• Don't block the ventilation holes of the RJ-6000 Series printer.
• The floor should be level and free from vibration.
• Avoid places near a device that produces heat, such as a stove
or heater.
• Avoid using the printer under strong light globes or halogen
lamps.
Environmental Conditions for the Installation Site
We recommend setting up the printer in a place that conforms to the condi-
tions in the following table.
With regard to temperature and humidity in particular, even if the conditions
fall within the ranges indicated, places subject to sudden changes should be
avoided.
We recommend setting up in a place that can be air conditioned in order to
maintain constant temperature and humidity.
Area for Installation At least 3 m 2 with a doorway of 1.5 m
Floor Strength At least 2490 Pa (300 kg/m 2 )
Power Supply Voltage 100 V to 120 V AC 10% or
200 V to 240 V AC 10%
Frequency 50/60 Hz 1%
Capacity Use a power outlet rated for at least 10 A
Temperature 10˚C to 35˚C (16˚C to 25˚C for assured
printing accuracy)
Variation rate: Not more than 2˚C per hour)
Humidity 35% to 80% (50% to 60% for assured
printing accuracy) with no condensation
Variation rate: Not more than 5˚C per hour)
Usage Environment
14 RJ-6000 Series USER GUIDE Basic Edition
CAUTION