Fisher VDC-D2184VA - Manual (Page 12)

ADJUSTMENT
Adjusting the lens Once the camera has been installed, adjust the lens section.
1 Tighten the pan adjustment screw.
Model: VDC-D2184VA
Loosen the pan adjustment screw, adjust the panning position of
the lens and then re-tighten the screw.
Model: VDC-D1184VA
Remove the lens unit A from the pan chassis, loosen the pan
adjustment screw B, turn the chassis to adjust the panning
position to a position where one of the three screw holes C is
visible, and then re-tighten the screw.
2 Loosen the tilt adjustment screw, adjust the tilting position of the
lens and then re-tighten the screw.
3 Loosen the zoom lever screw, turn the zoom lever
counterclockwise to determine the zoom position while viewing
the camera images on the monitor, and then re-tighten the screw.
4
Loosen the focus lever screw, turn the focus lever
counterclockwise to determine the focus position while viewing
the camera images on the monitor, and then re-tighten the screw.
Note: Be careful not to touch the lens section when changing the
angle of the camera.
3
4
1
2
A
B
C
C
C
Model: VDC-D2184VA
Model: VDC-D1184VA
L5AK4/US, L5AL4/US GB 2003, 6, 6
English
11