FRIGIDAIRE Outdoor Grill with Electronic Ignition - Manual (Page 5)

IMPORTANT: Remove all protective plastic film from
stainless steel parts prior to assembly/use. This film
is installed at the factory to prevent damage that
could occur during shipment and handling.
SIDE SHELF ATTACHMENT
1. Attach the shelf to the left side of grill by inserting the
shelf hooks into the slots on the side of the grill and
pushing down on the shelf assembly until level with
grill. (See Fig. 1)
2. Lock the shelf in place by inserting (2) self tapping
screws into shelf. (See Fig. 2)
INTERIOR PARTS INSTALLATION
1. Install the bottom Flavor Grids in the lower cutouts and
around the igniters. (See Fig. 3)
2. Insert the top row of Flavor Grids with the 90 degree
angled heat shield (bottom side of flavor grid) facing the
rear of the unit into cutouts with triangle ridges facing
up. (See Fig. 4-5)
3. Install cooking grates on the ledges provided on the grill
to create your cooking surface. (See. Fig. 6)
4. Place warming shelf on support brackets by setting it
flat across brackets allowing the two holes to line up
with the holes on each bracket. (See Fig. 6)
5. Remove label from drip tray and verify that the tray is
installed correctly. The drip tray is located underneath
the grill, inside the storage compartment. (See Fig. 7)
5
Grill Assembly
Fig. 1
Fig. 2
Shelf Hooks
Fig. 3
Fig. 4
Fig. 5
Bottom Flavor Grids
in between burners
Faces the back of
the grill
Fig. 6
Fig. 7
Cooking Grates
Warming Shelf
Drip tray slides sideways on to the mounting
brackets from the left side of the cart to the right.
Drip Tray