FUJITSU DESKPOWER 6000/SS - Manual (Page 72)

63
■ LAN adapter specifications
LAN controller Built-in Intel 82801BA (IHC2) + 82562EM
RAM for send/receive buffer 3KB each for sending and receiving
External interface ISO8802-3 100BASE-TX/10BASE-T
Transfer media Twisted pair cable *1
(100Mbps: Category 5, 10Mbps: Categories 3 to 5)
Transfer method Base band
Access method CSMA/CD
Data transfer speed 100Mbps, 10Mbps
Wiring shape Star shape
Maximum segment length 100m
Maximum number of nodes per segment Depends on the hub unit *2
*1: To appropriately run the network at 100Mbps, use a category 5 or higher unshielded twisted pair (UTP) cable. Data may be lost
if a category 3 or 4 cable is used.
*2: The “hub unit” refers to a 100BASE-TX/BASE-T concentrator.
Point
The standard LAN of this PC automatically adapts to the speed of the connected network. After
the network speed is changed due to the replacement of hub units or other reasons, be sure to
use a cable of an appropriate data grade for the speed.
■ Sound specifications
Sound controller Built-in Intel 82801BA I/O Controller Hub2 + Cirrus Logic CS4299
PCM recording/playback Sampling rate: 48 kHz maximum
functions 16-bit Stereo
Simultaneous playback/recording function
*1: Since the disk capacity specified in this manual is based on the conversions of 1MB = 1,000 2 bytes and 1GB = 1,000 3 bytes, the
actual capacity displayed on Windows using the conversions of 1MB = 1,024 2 bytes and 1GB = 1,024 3 bytes is smaller than that
specified in this manual.
Disk capacities are based on conversion of 1 MB = 1000 2 bytes and 1 GB = 1000 3 bytes. Actual disk capacities based on conversion
of 1 MB = 1024 2 bytes and 1 GB = 1024 3 bytes are displayed on Windows as smaller than those described on this manual.
Point
Note that the specifications of this PC may be revised without notice.