Furuno NAVPILOT 500 - Manual (Page 69)

MN-1
MENU TREE
[MENU] key
PARAMETER SETUP SEA STATE ( FULL-AUTO, SEMI-AUTO, MANUAL-CALM,
MANUAL-MODERATE, MANUAL ROUGH)
DEVIATION LEVEL (AUTO, LEVEL)*
MANUAL PARAMETERS
AUTO TRIM
(OFF, ON , 1-100, 40 )
ADVANCED AUTO ( OFF , ON)
AUTO NET TOWING ( OFF , ON)
NAV MODE ( XTE , COURSE)
NAV MODE DATA SOURCE ( PORT 1 , PORT 2)
RADIUS OF ORBIT (0.05 to 9.99 nm, 0.50 nm )
SPIRAL SPEED (0.1 to 8.0 kt, 1.0 kt )
FISHING MODE ( OFF , ORBIT TO PORT,
ORBIT TO STBD, FIGURE EIGHT)
WAYPOINT SWITCHING ( AUTO , MANUAL)
SPEED CALCULATION ( SOG , STW, MANUAL)
STBY mode menu
ALARM MENU AUDIO ALARM ( INTERNAL BUZZER , INTERNAL +EXTERNAL BUZZER)
ALARM INTERVAL ( SHORT , LONG, CONTINUE)
WATCH ALARM ( OFF , ON)
DEVIATION ALARM (1 to 90 , 90 )
XTE ALARM ( OFF , OUT, INTO)
SPEED ALARM ( OFF , UNDER, OVER, INSIDE, OUT OF RANGE)
DEPTH ALARM ( OFF , SHALLOW, DEEP, INSIDE, OUT OF RANGE)
TEMP ALARM ( OFF , UNDER, OVER, INSIDE, OUT OF RANGE,
CURRENT RIP)
TRIP LOG ALARM ( OFF , ON)
CLEAR TRIP LOG ( NO , YES)
TEST ( OFF , PROCESSOR UNIT, CONTROLLER UNIT, HEADING SENSOR,
KEYBOARD TEST, SCREEN TEST, RUDDER TEST)
SYSTEM SETUP KEY BEEP (OFF, ON )
LOCK ( ULOCK , LOCK)
PANEL DIMMER (1 to 8, 8 )
SYSTEM DATA
*: Available only when FULL-AUTO is selected in SEA STATE.