beautypg.com

3 fi-5000n's network settings, Network connection, Language configuration – FUJITSU fi-5000N User Manual

Page 12: Network settings

background image

4

2.3 fi-5000N's Network Settings

Network Connection

1. Turn on the power of the scanner and fi-5000N.

Refer to the scanner product manual for details on
turning on the power of the scanner.
Turn on the fi-5000N by pressing the "|" of the power
switch located at the back of the fi-5000N.

2. When "The network cable is disconnected"

appears on the fi-5000N’s Message Display,
connect the network cable to the network con-
nector at the back of fi-5000N.

The following screen appears.

If the network support DHCP and the process goes
successfully, "Place your finger on the sensor." mes-
sage appears.

Language Configuration

With the following procedure, change the language
setting if necessary.

1. Open the fi-5000N’s cover and press the [SET]

key.

The following settings screen appears.

2. With the [L] key, select "Administrator Setup",

and press the [ENT] key.

The screen to enter the Administrator's PIN
(personal identification number) appears.

3. Enter the Administrator PIN (the default setting

is "5000"), and press the [ENT] key.

The following screen appears.

4. With the [L] key, select "Change Language",

and press the [ENT] key.

The language selection screen appears.

5. Press the [K] or [L] key to select the language

and press the [ENT] key.

The message "selected language changed" appears
and the messages will be displayed at the selected
language.

Network Settings

1. Open the fi-5000N’s cover and press the [SET]

key.

2. With the [L] key, select "Administrator Setup",

and press the [ENT] key.

The screen to enter the Administrator's PIN
(personal identification number) appears.

HINT

When the above screen remains still,
open the cover of the fi-5000N, and
press the [ESC] key.

The following screen appears, and
the IP address obtaining operation is
canceled.

Power OFF

Power ON

Obtaining IP address

from DHCP server...

Cancel:[ESC]

Cannot obtain IP

address from DHCP

server.

Setup:[SET]

Setup

Register Finger

Change PIN Code

Show Network Config

PIN:_

Cancel:[ESC]

Administrator Setup

Configure Network

Pull Mode Authentic

Auto Logout Time