Frymaster YPF95 - Manual (Page 20)

YPF95 SERIES PORTABLE FILTRATION SYSTEMS
CHAPTER 6: TROUBLESHOOTING
6-2
6.2 General Troubleshooting (cont.)
Pump won't
start.
- Tripped circuit breaker.
- Incorrect or no line voltage.
Pump stops
during filtering
process.
- Allow filter unit to cool for at least 45 minutes and
then press the pump reset button on the side of the
filter.
- Turn filter pump "OFF". Allow oil to cool then empty
pan. Verify filter paper is clean and properly
installed. Refill pan and restart process.
Pump starts
and abruptly
stops.
- Reset circuit breaker.
- Pump is blocked or wiring is loose. Call FASC for
service.
- Filter pan suction tube is blocked. Use a thin, flexible
wire to unclog.
- Motor failed; call FASC for service.
Pumping is
erratic.
- Verify that filter paper is properly installed under
hold-down ring.
Oil not being
returned to
frypot.
- Solidified oil or sediment is likely clogging the filter
hose. Clear hose.
- Clogged filter paper. Scrape off excess sediment or
replace filter paper.