FujiFilm FinePix A800 - Manual (Page 131)

131
Troubleshooting
Continued Q
Flash
Cannot use the
flash.
The shutter button was pressed while the
flash was charging. Wait until the charging is completed
before pressing the shutter button.
53
The Shooting mode is set to , ,, ,
, , or .
Change the Shooting mode.
43, 44
The batteries have run out. Load new or fully charged batteries. 16, 18,
117
The flash is set to C SUPPRESSED
FLASH mode. Set to another flash mode excluding the
C SUPPRESSED FLASH mode.
52
The flash settings
are restricted and
cannot be
selected. The Shooting mode is set to AUTO, ,
, b, , ,, ., /, , , ,
, , , , , or .
The flash settings are restricted because
the camera settings are tailored to the
scene being shot. Change the Shooting
mode for a wider range of flash settings.
43, 44,
53
The playback
image is dark
even though the
flash was used. The subject is too far away. Move to within the effective flash range
before taking the picture.
51, 53
Your finger was covering the flash. Hold the camera correctly.
27
Photographed
images
The image is
blurred.
The lens is dirty. Clean the lens. 116
{ appeared when taking pictures. Check the focus on the subject and take
pictures. 29, 31,
124
| appeared when taking pictures. It may cause camera shake. Hold the
camera steadily.
30, 124
There is speckling
on the image.
The picture was taken with a slow shutter
speed (long exposure) in a high-
temperature environment. This is a characteristic of CCDs and does
not indicate a camera fault.
–
Matters Problems Possible causes Solutions Page