Meridian Audio SRC-2010 - Manual (Page 56)

Appendix B Appendix B
Troubleshooting
If you have trouble configuring or operating the SRC-2010, first check that you have
inserted the batteries correctly (page 8). Then check the items below.
Symptom Remedy
The SRC-2010
doesn’t operate your
device. •
Move closer to the device. The maximum
operating distance is approximately 10 m e-
ters.
•
Ensure that you are aiming the SRC-2010
directly at the device and that there are no
obstructions between the SRC-2010 and
the device.
•
Ensure that you have used the learning
function (page 23) to configure the device.
•
Make sure that the desired device on the
SRC-2010 LCD panel has been selected.
You cannot operate a
device even after con-
figuring the device
using the learning
function (page 23). •
Make sure that you have correctly “mapped”
your device’s remote control to the SRC-
2010.
•
Clear the device data from the SRC-2010
(page 26) and carry out the learning func-
tion again (page 23).
You see an “error”
display during the
learning procedure. •
Try the learning procedure again (page 23).
You see an “error”
display during opera-
tion. •
The button that you pressed has not been
configured. Configure the button using the
learning procedure (page 23).
The LCD screen
turns off. •
The SRC-2010 is preset at the factory to
automatically switch the LCD off after 25
minutes if left unused. Just press the
Hardware Access Button to turn the
SRC-2010 back on again.