Follett HCE1400W - Manual (Page 6)

6
Dimensions and clearances
Entire front of icemaker must be clear of obstructions/connections to allow removal.
1" (26mm) clearance above icemaker for service.
1" (26mm) minimum clearance on sides.
The intake and exhaust air grilles must provide at least 170 sq in (1098 sq cm) of open area.
Air-cooled model HCC1400A icemakers – 18" (458mm) minimum clearance between discharge and air
intake-grilles.
Keep ventilation openings in the appliance enclosure or built-in structure, clear of obstruction.
Front View Side View Back View
Air intake
PSIG
THE USA MADE IN
OZ PHASE SINGLE
LOW SIDE CHARGE
PART NO
R R
HZ
Easton Pennsylvania
208264 AMPS AMPS
VOLTS
SERIAL NO CORPORATION MODEL
Service No. Product Module No.
REFRIGERANT
FULL LOAD AMPS
Stock Module Identification Plate DESIGN PRESSURE HIGH SIDE
MAX. BRANCH CIRCUIT FUSE SIZE MIN. BRANCH CIRCUIT AMPACITY
MOTOR COMPRESSOR THERMALLY PROTECTED
C NSF U L U L
Air exhaust
21.05" (535mm)
23.50"
(597mm)
21.28" (541mm)
Air exhaust
both sides
Ice transport hose connection
6.95"
(177mm)
3/4" MPT drain
3/8" OD push-in water inlet
23.77" (604mm)
15.56"
(396mm)
2.53"
(65mm)
2.43" (62mm)
1/4" FPT condensor drain
(water-cooled only)
1/4" FPT condensor inlet
(water-cooled only)
29.63" (753mm)
Cord only
CAUTION
• Keep ventilation openings in the appliance enclosure or built-in structure, clear of obstruction