Fisher & Paykel OD302 - Manual (Page 11)

11
to ensure that the ‘stop-lock’ feature of
the shelf works correctly (see diagram
opposite).
4
Refit the oven doors. This is done by: Place
both upper hinge arms in the top slots and
both lower hinge arms in the lower slots.
Push the hinges as far as they will go until
the slot in the lower arm locates in the
hinge support.
Lower the door gently. Push the catches
away from you off the hooks. Make sure
that they disengage properly.
Raise the door slightly and ensure the
catches are released from the hooks. The
door can now be closed.
IMPORTANT!
Do not stand or sit on the doors. Doing
so may damage the product.
Checklist
1
Make sure product is level and securely
fitted to the cabinetry and both oven
doors open and close freely.
2
Make sure all the internal packaging has
been removed from the oven cavity.
3
Make sure all oven vents and openings are
clear and are free of any obstruction.
IMPORTANT!
Failure to make sure all oven vents are
unobstructed may result in poor product
performance.
4
Turn the power to the oven on. The clock
should light up and blink 12:00pm.
5
Set the clock to the current time.
6
Turn the oven function switch to ‘Bake’ and
the oven temp switch to 350
o
F. Air should
blow out of the vent at the bottom of the
oven. Inside the oven cavity all three oven
lights should come on. After five minutes
open the oven door and the air inside
should feel warm and the top element
should be glowing red.
7
Turn both the oven function switch and
oven temp switch back to off and repeat
for the other oven if product is a double.
Troubleshooting
IF THE OVEN DOES NOT OPERATE:
Check that the circuit breaker has not
tripped or the fuse blown.
Make sure that the electrical connections
have been correctly made.
Make sure that power is being supplied to
the oven.
Make sure the voltage is correct across all
phases.
IF YOU NEED ASSISTANCE:
If a fault occurs consult the Problem Solver
Section of your User Guide book.
Call your local Customer Care representative
on 1-8889 FNP USA (1-8889 367 872).
Please have the model and serial number of
your product ready for the Customer Care
representative.
WARNING
Hot Surface Hazard
The element will
become hot during use.
Do not touch the top
element.
Doing so could result in
burns or scalds.
US
Installation instructions