Fisher & Paykel OD302 - Manual (Page 10)

10
Attachment
1
Feed the electrical supply cable into
1’’ hole cut out of the rear of the oven
cabinet.
Slide the product into the oven cabinet,
pushing the product between the two
oven cavities or by the edges of the oven
cavity.
Make sure that the electrical supply cable
can drop straight down using the recess
on the rear of the oven into the cable
entry hole in the rear of the oven cavity.
If the product does not sit flush with the
front of the oven cabinet, make certain
that the electrical supply cable has not
jammed behind the product. Ensure
the bottom vent is not blocked off or
damaged.
2
Securely fasten the oven to the cabinet
using the screws provided. Insert the
screws through the holes in the side
extrusions and through the spacers placed
between the side extrusion and the
kitchen joinery (see diagram opposite).
Do not over tighten screws.
3
Replace the oven trays and wire shelves.
The shelves have a front and back. Insert
them into the oven in the correct way
WARNING
Very Heavy
Do not attempt to
lift this product
unassisted.
Lifting unassisted may
cause serious injury.
Installation instructions