FIAT Uno 45 - Manual (Page 98)

3 Working at the transmission, disconnect
the speedometer cable by unscrewing the
knurled retaining ring (photo).
4 Withdraw the cable through the bulkhead
grommet.
5 Refit the new cable assembly by reversing
the removal operations.
24 Windscreen wiper blade and
arm - removal and refitting
1
1 The wiper blade can be removed once the
arm has been pulled away from the glass and
locked in position.
2 Depress the small tab (A) and push the
U-shaped carrier out of the hook (B) of the
wiper arm. The blade can then be withdrawn,
passing the wiper arm hook through the
slot (C) in the blade stretcher (Fig. 9.5).
3 Before removing the wiper arm, it is
worthwhile sticking a strip of masking tape on
the screen to indicate the setting of the arm
and blade as a guide to refitting.
4 Flip up the plastic cover and unscrew the
arm retaining nut. Pull off the arm from the
splined drive spindle (photo).
5 Refitting is a reversal of removal.
25 Windscreen wiper motor -
removal and refitting
2
1 Open the bonnet and disconnect the
battery negative lead.
2 Remove the wiper arm and blade as
previously described.
3 Prise off the sealing cover from around the
drive spindle and then unscrew the drive
spindle bezel nut.
4 Pull back the weathersealing strip from
above the wiper motor location and remove
the two screws which are exposed (photo).
5 Withdraw the motor/gearbox with
protective cover from under the lip of the
upper bulkhead. Disconnect the wiring plug
(photos).
6 Refitting is a reversal of removal.
26 Tailgate wiper blade and arm
- removal and refitting
1
1 Pull the wiper arm from the glass until it
locks.
2 With the thumb nail pull down the tab to
release the peg (B) from the hole (A) (Fig. 9.7).
Pull the blade from the arm.
3 To remove the arm, flip up the plastic cover
and remove the nut exposed. Pull the arm
from the drive spindle.
4 Refitting is a reversal of removal.
Electrical system 9•9
Fig. 9.5 Windscreen wiper blade fixing
(Sec 24)
A Tab B Wiper arm C Blade slot
24.4 Windscreen wiper arm nut 23.3 Speedometer cable connector at
transmission
Fig. 9.7 Tailgate wiper blade fixing (Sec 26)
A Hole B Peg
25.5B Removing windscreen wiper motor 25.5A Windscreen wiper motor cover
25.4 Removing windscreen wiper motor
mounting screws
Fig. 9.6 Windscreen wiper motor
components (Sec 25)
1 Gears 4 Intermittent
2 Crank arm control unit
3 Shaft gear 5 Motor yoke
9