Side view, Rear view – FRIGIDAIRE P/N 134296400A (0404) User Manual

Page 6

REVERSING DOOR SWING

Your dryer is designed so the door swing may be reversed at
any time without additional parts. Conversion is accomplished
by transferring hinges to the opposite side of the cabinet.

To change the direction of the door opening:

1. Open the dryer door. Remove the four hinge hole plugs from

the left side of the door opening. Place nearby for future
installation. NOTE: You may need a plastic knife to help pull
out the plugs. Be careful not to scratch the paint.

2. Remove the four screws that secure the door hinges to the

dryer front panel (see below). NOTE: Remove one screw
from each of the two hinges first. Hold the door firmly before
removing the last two screws.

3. Rotate the door 180° and reinstall the door hinges to the

dryer front panel with the four screws.

4. Install the four hinge hole plugs in the open screw holes on

the right side of the door opening.

UNPACKING

1. Using the four shipping carton corner posts (two on each

side), carefully lay the dryer on its left side and remove foam
shipping base.

To prevent damage, do not use the control panel

as a means to pick up or move the dryer.

NOTE: On under counter model clothes dryers, the top panel

may be removed for installation.

2. Return the dryer to an upright position.

PACKING

FOAM

SHIPPING

REMOVE 4 SCREWS

(ONE FROM EACH

HINGE FIRST)

ROUGH-IN DIMENSIONS

TOP CONSOLE MODELS

(68.6 cm)

SIDE VIEW

OPTIONAL

VENT KNOCKOUT

4 3/8"

(11.1 cm)

47 1/2"

(120.7 cm)

REAR VIEW

(68.3 cm)

(2.54 cm)

(110.7 cm)

(6.5 cm)

(9.5 cm)

3/8" (0.96 cm) DIA.

GAS PIPE

ELECTRIC CONNECTION

13 1/2"

(34.4 cm)

3 3/4"

(9.5 cm)

36"

(91.5 cm)