Freecom Technologies Media Player II - Manual (Page 38)

Freecom MediaPlayer II
EN
4
Chapter 4: Installing BT_SAMBA
BT Player is a system software, it consists of the operating system (Linux+AP) and the
application software (BT_SAMBA).
4.1 Initial installation
When inserting a hard disk to the system for the first time, the system will start with the
hard disk format interface.
You can also press "SETUP" on the remote control to open the Setup menu and select
"HDD Format" to format HDD.
Step 1: Press " " and " " on the remote control to make a selection.
When highlighting the YES button, press "ENTER" to enter the next step. Otherwise,
select "Cancel" to return.
Step 2: Hard disk format
Press " " and " " on the remote control to select "Back" or "Format". When the
"Format" button is highlighted, press "ENTER" to start. Otherwise, select "Back" button
to go back.
Step 3: Install BT/Samba Extension
After HDD format is complete, the system will install BT/Samba automatically. Please select
OK for the next step. The system will auto install according the following steps:
1. Install BT/Samba Extension
2. Install Bit-Torrent Support
3. Install Samba Server Support
4. Install Web Support
When the installation is complete, the system will display a success message at the end
of every step.