Fisher-Price BARBIE 74518 - Manual (Page 16)

• Lift the seat to access the battery compartment.
1
• Place the battery upright in the battery compartment.
Make sure the battery connector extends towards
the rear of the vehicle.
• Make sure a Power Wheels ® 25 amp fuse in good
condition is installed in the battery.
• Insert the ends of the battery retainer into the holes in
the battery compartment.
• Lower the battery retainer over the top of the battery.
• Insert a #8 x 7 /
8
" screw through the battery retainer and
into the battery compartment.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.
3
• Squeeze the tabs on each side of the motor harness
connector.
• Plug the battery connector into the motor harness
connector.
Please Note: If the battery connector will not plug into
the motor harness connector, turn it over and try again!
Do not force the battery connector into the motor
harness connector.
4
16
Battery Installation
H
Important Note: Use only a Power Wheels ® Type H 6 volt battery with a Power Wheels ® 25 amp fuse installed. Use of
any other battery or fuse will damage your vehicle. Be sure to insert the battery correctly and always follow Power Wheels’
instructions for use and care. Make sure that you charge the battery for at least 18 hours before operating your vehicle for
the first time. After first time use, charge the battery for at least 18 hours after each use. Never charge the battery longer
than 30 hours. Failure to follow these instructions may damage your battery and will void your warranty.
Seat
Battery Retainer
Battery Connector
Rear of Vehicle
Battery
#8 x 7 /
8
" Screw – 1
Shown Actual Size
Motor Harness Connector
Battery Connector
2