Fujitsu Siemens Computers S7110 - Manual (Page 7)

7
Drive1 Submenu of the Main Menu
The Drive1 submenu allows you to configure secondary
ATA devices. Note that actual optical drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
Figure 4. Drive1 Submenu
Table 4: Fields, Options and Defaults for the Drive1 Submenu of the Main Menu
Menu Field Options Default Description
Type: ■ Auto
■ None
[Auto] Selects the ATA/ATAPI device type. Select Auto to have the device (CD-
ROM, CD-R/RW, DVD-ROM, etc.) automatically identified by the BIOS
at POST. If None is selected, the following Set-up items do not appear.
Multi-Sector
Transfers: ■ Disabled
■ 2 Sectors
■ 4 Sectors
■ 8 Sectors
■ 16 Sectors
[Disabled] This option cannot be changed when Auto is selected. Selects the
number of sectors per block for multiple sector transfer.
LBA Mode
Control: ■ Disabled
■ Enabled
[Disabled] Enables or disables Logical Block Addressing in place of Cylinder, Head,
Sector addressing. This option cannot be changed when Auto is selected.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select ATA/IDE drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
[None]
The drive is disabled.
Drive1 [HL-DT-ST DVDRAM GMA4082Nj]
Type: [ Auto ]
Multi-Sector Transfers: [Disabled]
LBA Mode Control: [Disabled]
Transfer Mode: [Standard]
Ultra DMA Mode: [Disabled]
▲
M a i n M e n u