Fujitsu Siemens Computers S7110 - Manual (Page 27)

27
Security Chip Setting Submenu of the Security Menu
The Security Chip Setting submenu is used to enable or disabled the embedded security chip.
Figure 17. Security Chip Setting Submenu
Exiting from the Security Menu
When you have finished setting the parameters on the Security Menu, you can either exit from setup utility or move to
another menu. If you wish to exit from setup utility, press the [Esc] key to go to the Exit Menu. If you wish to move to
another menu, use the cursor keys.
Menu Field Options Default Description
Security Chip: ■ Disabled
■ Enabled
[Enabled] Allows you to enable or disable the security chip. Note that this is only active if
a Supervisor Password has been entered. A reboot is required after exit to con-
figure the Security Chip correctly. Clear Security Chip option becomes select-
able after reboot.
Clear Security Chip –— [Enter] This field is not selectable until after the security chip is enabled and the system
is rebooted.
Security Chip State: ___ –— Display only, to indicate the state of the chip if it has been enabled or disabled.
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
▲
Main Advanced Security Power Savings Exit
Item Specific Help
PhoenixBIOS Setup Utility
Security Chip Setting
Security Chip: [Enabled]
Clear Security Chip [Enter]
Security Chip State: Enabled
Activated
S e c u r i t y M e n u