FieldServer Genisys FS-8700-133 - Manual (Page 8)

FS-8700-133 Genisys Manual Page 8 of 13
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
5.3 Client S ide Map Descriptors
5.3.1 FieldServer Related Map Descriptor Parameters
Column Title Function Legal Values
Map_Descriptor_Name Name of this Map Descriptor Up to 32 alphanumeric characters
Data_Array_Name
Name of Data Array where data is to be
stored in the FieldServer One of the Data Array names from “Data
Array” section above
Data_Array_Offset Starting location in Data Array
0 to maximum specified in “Data Array”
section above
Function Function of Client Map Descriptor COS_Poller, COS_Read , Wrbx
5.3.2 Driver Related Map Descriptor Parameters
Column Title Function Legal Values
Node_Name Name of Node to fetch data from
One of the Node names
specified in “Client Node
Descriptor” above
Data_Type*
‘Bit’ each byte of Indication statuses will be stored in 8
consecutive locations in the Data Array. Similarly while
writing; Control byte will be composed from 8
consecutive locations of the Dara Array.
‘Byte’ each byte of Indication statuses will be stored as
an 8-Bit Integer at the specified location. Similarly while
writing; Control byte will be composed from a single
location of the Data Array.
Refer to Appendix A.1
Bit, Byte
Address* Internally used parameter, if used specify value 0 0
Length*
Length of Map Descriptor
Number of indications to store or number of controls to
write as per Data_Type.
Bit: 1-256, 8
Byte: 1-32, 1
Genisys_OnValue_Change*
If this parameter is set to Yes, the driver will only send
controls if there is a value change when the Data Array
is updated.
Yes, -
5.3.3 Timing Parameters
Column Title Function Legal Values
Scan_Interval Rate at which data is polled ≥0.001s