Furuno 841 MARK-2 - Manual (Page 46)

34
Navigation aid, video sounder
connection
If your navigation aid can output data in
NMEA 0183 data format, your vessel’s posi-
tion in latitude and longitude, the range and
bearing to waypoint, speed, and course may
be input to this radar, and be seen in the bot-
tom text area.
Further, if your video sounder can output
depth in NMEA 0183 data format, depth can
be displayed on the navigation data displayed
in graph form during stand-by.
You will need an NMEA cable:
For navaid;
Type Code no. Remarks
MJ-A6SPF0012-050 000-134-424 6P-6P(5m)
MJ-A6SPF0012-100 000-133-817 6P-6P(10m)
For E/S;
Type Code no. Remarks
MJ-A6SPF0011-050 000-132-224 6P-4P(5m)
MJ-A6SPF0011-100 000-132-336 6P-4P(10m)
Two NMEA connectors are provided at the
rear of the display unit: the NMEA connector
and the OPTION connector.
Heading Sensor Connection
Heading signal can be connected to the
“HDG” connector. 10 m cable assembly is
optionally available.
Type Code no. Remarks
MJ-A6SPF0007-100 000-125-237 C-2000
MJ-A6SPF0009-100 000-125-236 AD-100
The OPTION connector
To connect external equipment to the OP-
TION connector;
1) Remove the plastic cover on the connector.
2) Connect equipment to J61 on the SPU Board
as shown in Figure 5-13.
SPU-9180
DISPLAY
UNIT
J61
VIDEO
SOUNDER
Cable supplied
with radar
(connector assy.
03-1796(5))
Cable supplied
with video sounder
Solder and
tape.
Figure 5-13 How to connect external
equipment to the OPTION connector
3) Cover signal cable at junction with display
unit with silicone sealant.
Distribution NAV data to the other
equipment
This radar can output NAV data received from
a navaid to an echosounder or video plotter
by making the modifications as shown in be-
low.
MODEL 841 MARK-2
J55
TX_H
TX_C
RD_H
RD_C
N.C.
SHIELD
J61
TX_H
TX_C
RD_H
RD_C
SHIELD
BRN
RED
ORG
YEL
GRN
Solder
NMEA cable
NMEA cable
Other Equipment
(Telesounder data
not be mixed)
Telesounder
TX_H
TX_C
RD_H
RD_C
N.C.
SHIELD
TX_H
TX_C
RD_H
RD_C
N.C.
SHIELD
03-1796(5P)
JP3(CUT) JP4