Fluke DSP-2000 - Manual (Page 21)

Getting Started
Quick Configuration
2
2-5
To change any of the settings shown in Table 2-3, proceed as follows:
1. Turn the rotary switch to SETUP.
2. If the setting you want to change is not on the first Setup screen, press
$Page Down to see additional Setup screens.
3. Use
D U to highlight the setting you want to change.
4. Press
! Choice.
5. Use
D U to highlight the setting you want.
6. Press
E to store the highlighted setting.
7. Repeat steps 2 through 6 to change additional settings.