Follett 110 Series - Manual (Page 15)

How unit works — SensorSAFE models
SensorSAFE models provide “touchless” ice and water dispensing. When a container is placed within the actuation
zone below the ice or water chute on SensorSAFE dispenser models, an infra-red signal reflects off the container and is
detected by the sensor. The sensor then sends a signal to the control board to activate the appropriate components to
dispense ice or water. LEDs on the board indicate when the board is receiving a signal from the sensors.
A safety, shut-off feature automatically shuts off dispensing after one minute of continuous activation. Dispensing can be
restarted by moving the container away and then returning it to the actuation zone.
Dispensing can be temporarily suspended for cleaning by depressing and releasing the clean switch, located under the
left side of the top front cover. Depressing and releasing the button a second time will return the dispenser to normal
operating state. If the clean switch is not depressed a second time, the dispenser will automatically resume normal
dispense operation (CLN LED goes out) after two minutes. An LED on the control board will light to indicate that the
dispensing has been suspended by activation of the clean switch.
WTR
S
1
7
M
RELAY #1
4
B RLY A
BIN SIGNAL
T-STAT
SWITCH
(220/230 VAC)
ICE MACHINE
POWER
RD
RED BLUE
ORANGE
RED
PUR
PUR
ORANGE
WHITE
WHITE
WHITE
WHITE
WHITE
WHITE
WHITE
WHITE
3 2 1
TIMER
BLA
C
K
4x4 JUNCTION BOX
BLUE
WHITE
CLEAN
SWITCH
NEUTRAL WTR
CLN
WM
SOL
L1
PWR
GND
WTR ICE
MAIN POWER SWITCH
YELLOW
YELLOW
GRN
(16 VDC)
BIN SIGNAL
ICE MACHINE
1
RELAY #2
7
4
B RLY A
#2
BLACK
BROWN
BLUE
GREEN/YELLOW
220V 60HZ
230V 50HZ
RED
ORANGE
BLA
C
K
WHI
TE
BLA
CK
GREEN WHI
T
E
#1
15