beautypg.com

Installing satellite-fill icemakers, Installing top mount icemakers – Follett 110 Series User Manual

Page 10

background image

Installing Satellite-fill icemakers

Models C/E110CR400A/W




1. Install Satellite-fill icemaker following instructions in icemaker manual.

2. Run uninsulated ice transport tube from dispenser through ice transport tube knock-out, (Fig. 5G) or through counter

opening to icemaker.

3. Insulate ice transport tube by sliding insulation over tube.

4. Adjust insulation to cover all exposed ice transport tubing including tubing inside dispenser cabinet.

5. Check that insulated ice transport tube runs continuously uphill (with no dips) from icemaker to dispenser.

6. Run bin signal wire from dispenser through utility knockout, (Fig. 5F) or counter cutout to the icemaker and connect

bin signal wire (two-conductor twist lock) to bin signal plug on icemaker.

7. Plug dispenser power cord into 20 amp rated NEMA 5-20 wall socket.

8. Turn on dispenser water supply and check for leaks. Replace splash panel.

9. Remove top front cover by removing two screws at bottom corners of cover. Lift cover slightly and pull forward. Turn on

power and bin signal rocker switches. Replace front cover and secure with screws. Test operation.

10. Clean and sanitize icemaker following instructions in icemaker manual. Discard sanitized ice.

11. Clean and sanitize dispenser hopper following instructions on page 13. Installation is complete.

10

engaging pin

5mm (3/16") ice tube hole

ice hose mounting bracket

ice level control stat

ice tube

26mm

(1")

See Icemaker Installation Manual (form #00124453) for critical installation instructions for Satellite-
fill icemakers. Failure to comply with these instructions will result in poor performance and void
warranty.

!

Fig. 6 – Ice transport tube and ice level control stat mounting for freestanding dispensers and countertop units
with Satellite-fill icemaker

Installing top mount icemakers

Models C/E110CT400A/W

Dispensers with top mount icemakers cannot be mounted on legs. They must be bolted to counter.
Use gloves when lifting icemaker to protect hands from sheet metal edges.

!