Fisher & Paykel DD36 - Manual (Page 26)

24
User maintenance instructions
Important!
Disconnect the DishDrawer® from the power supply and allow all its parts to cool before any cleaning or
maintenance.
Cleaning the surfaces
Important!
We do not recommend the use of the following cleaning aids on your DishDrawer® as they may damage
the surfaces:
Plastic or stainless steel scouring pads Abrasive, solvent, household cleaners
Acid or alkaline cleaners Hand washing liquids or soap
Stainless steel cleaners or polishes Laundry detergents or disinfectants
1 Wipe with a clean damp cloth. Take care not to wet the control panel.
2 Dry with a clean lint-free cloth.
Cleaning the drain filter, spray arms and filter plate
We recommend that the drain filter is cleaned
whenever there is evidence of food particles.
The spray arms may need cleaning about once a month
in normal use or more often should the need arise.
The filter plate should not normally need cleaning.
Food particles remaining on its surface can be wiped
off with a clean, damp cloth.
Important !
If a dishwasher cleaner/descaler is used, you must run
a wash programme with detergent immediately
afterward to prevent any damage to your DishDrawer®.
The DishDrawer® must be used with the filter plate,
drain filter and spray arm correctly in place.
Cleaning the drain filter
1 Unplug the DishDrawer® or turn it off at the power
supply.
2 Ensure the tines above the drain filter are in the upright
position.
3 Lift and remove the drain filter. It is normal to find some
water under it.
4 Empty, rinse clean under running water and replace
back into the allocated space.
5 Ensure the drain filter is flush with the filter plate.
6 Plug the DishDrawer® back in or turn it on at the
power supply.
Spray
arm
Filter
plate
Drain filter
Wash pump housing