Optional equipment, Temperature meter, Ad b – FireplaceXtrordinair Elite Fireplacextrodin 36-Elite User Manual

Page 22

2 0

Optional Equipment

Travis Industries

9 3 5 0 8 0 9 1

2 2 0 6 0 2

Temperature Meter

The temperature meter displays the temperature of the combustor, allowing the operator to monitor
combustor light-off. To obtain a suitable temperature meter, contact the manufacturer listed below:

Condar Company
P.O. Box 250
108 Mill Spring Road
Columbus, NC 28722-0250
(828) 894-8383
Model: 9-88

Before installing the faceplate, route the thermocouple wire to the catalytic combustor (see the
illustration below). With the wire in place, the faceplate can be installed.

Route the wire along the outside of the

firebox assembly, behind the location

where the face attaches (either side).

Tuck excess wire to the side so it does

not contact the firebox.

Remove this screw and pass the

soldered end of the included

thermocouple wire through the hole.

NOTE: if the hole is not present, drill a

1/8" diameter hole (drill frominside the

firebox).

5/16" Nutdriver

Insert the soldered end of the wire into the

catalytic combustor approximately 1/2"

Run the wire through this

notch

NOTE: if the notch is not

present, file a notch in the

arched piece of metal)

Attach the molex connector from the wire to the

quick-connect on the temp meter. Route the

wire so it exits below the faceplate.

Temp Meter

NOTE: If the connector is not present, connect the wires

to the two posts on the back of the temp meter. The

yellow inner wire goes to the positive (+) pole.