Fisher & Paykel Smart Drive GWLO8 - Manual (Page 37)

HOT water temperature
light is flashing
COLD water temperature
light is flashing
HOT and COLD water
temperature lights are flashing
HIGH water level light is
flashing
First rinse light or spin light
is flashing
First RINSE or SPIN light is
flashing as well as the SPIN
SPEED light.
IF THE MACHINE BEEPS
CONTINUOUSLY
1. Hot faucet has not been turned on.
2. Inlet hose screens may be blocked.
3. Hot water supply is not hot enough to maintain the
wash temperature you have selected. Select a lower
wash temperature.
4. Inlet hoses connected the wrong way around.
1. Cold faucet has not been turned on.
2. Inlet hose screens may be blocked.
3. Faucets connected the wrong way around.
4. Cold water temperature exceeds recommended
limits (See separate INSTALLATION INSTRUCTIONS).
1. The inlet hoses have not been turned on.
2. The drain hose is too low & the water is siphoning
out of the machine. (See separate INSTALLATION
INSTRUCTIONS).
3. Water flow is very low. Check screens on inlet hoses and
water valves for any blockage.
1. The machine is overloaded and can not agitate.
Ensure the machine is stationary. Remove clothes
until the remaining clothes can move freely.
2. Remove the agitator. Check that no foreign object is
trapped under the agitator
1. The machine has a suds build-up. (Too much
detergent may have been used for the amount of soil
in the load.) Wait for suds to dissolve. Rinse clothes
using a deep rinse.
1. Wash load is out of balance. Ensure the machine is
stationary. Manually redistribute the load. Check
machine is level. (See separate INSTALLATION
INSTRUCTIONS).
1. Unplug machine from the wall. Wait 15 seconds,
plug back in and operate machine.
2. If the fault re-occurs repeat step 1.
3. If the machine still will not work call your Authorized
Service Agent or Fisher & Paykel Dealer.
IF YOUR SMART DRIVE BEEPS FOR HELP
Your Smart Drive is capable of diagnosing its own troubles. If your Smart Drive gives a short
burst of beeps every 5 seconds it is telling you that it has a problem which YOU can solve
using the checklist below.
MACHINE IS GIVING A SHORT
BURST OF BEEPS* AND...
POSSIBLE SOLUTIONS
* The short burst of beeps is the same sound your washer makes when you plug your machine in.
35
1133 LDY Use & Care (USA) 16/5/01 3:34 PM Page 37