FujiFilm 90 - Manual (Page 15)

CHINESE
15
LOADING THE BATTERY
Your camera uses one 3V lithium battery, type CR2/DL CR2.
To load the battery.
1 Move the battery cover release knob.
2 Open the battery cover.
1
3
2
4
3 Insert the battery following instruction in the diagram on the inside of the battery
cover paying particular attention to the position of the
, and . poles of the bat-
tery. The battery must be inserted the right way or the camera will not function.
4 When the battery is inserted correctly, close the battery compartment cover by
pressing it until it snaps into place.
∗
Do not apply excessive force when opening or closing the battery cover.
∗
One fresh lithium battery should be sufficient for approximately 250 exposures (based on our
test conditions).
∗
When traveling, take extra batteries to provide power for extra exposures. This is particularly
important if you visit areas where fresh batteries may be difficult to obtain.
∗
Check the battery capacity symbol before using your camera. ( → p.17)
∗
After changing the batteries, reset the date to assure accurate date/time recording. (
→
p.18)