beautypg.com

Important safety information – Firex FADCQ User Manual

Page 6

background image

6

Important Safety Information

Required Power Supply

• This combination smoke-CO alarm requires

constant 120V AC power AND/OR a working
9-volt battery to operate properly.

Recommended Coverage

• Because smoke in one area may not reach a

smoke alarm in another, smoke alarms are
recommended in every room and on every
level of the home. Interconnected alarms can
provide better whole-home protection than
stand-alone alarms.

• CO alarms are recommended near bedrooms

and sleeping areas where they can wake
sleeping residents. Additional CO alarms are
recommended 5-20 feet from sources of CO
like a furnace, water heater, or fireplace.

Installation/Interconnect

• This combination alarm should be installed

only by a licensed qualified electrician.
Observe and follow all local and national elec-
trical and building codes for installation.

• Connect this combination alarm ONLY to

compatible devices listed in this manual.

Compliance

• This combination alarm is designed to be used

in ordinary indoor locations of single-family
households only.

• The sensitivity of both the smoke and CO

sensors, and the horn patterns for both warn-
ings, comply with UL/ULC standards.

General Limitations

• This alarm cannot alert every household mem-

ber every time if it cannot be heard because of
location, obstructions, ambient noise, condi-
tion of residents, etc. It is not intended to alert
residents who are hard of hearing.

• ALL alarms have limitations. This combination

smoke-CO alarm is not foolproof and is not
warranted to protect lives or property. It is not
a substitute for insurance.

• Because it is possible for the alarm to fail at

any time, you must test the alarm weekly and
replace it every 5 years.

Smoke alarms can sound an alarm only when

smoke reaches their sensors. Smoke may not
reach the smoke alarm QUICKLY ENOUGH to
ensure safe escape. They do not sense heat,
flame, or gas.

CO Alarms are designed to detect carbon

monoxide gas from any source of combustion
that reach their sensor. They are NOT
designed to detect smoke, fire, or any other
type of gas.

IMPORTANT: Please see Chapter VII
“Important Safety Information” for detailed
safety considerations and alarm limitations
before installing or using this alarm.