Franklin Executive Organizer RF-1000 - Manual (Page 49)

48
Replacing the Battery
This organizer uses two AAA batteries. Before you follow these
steps you should have a small Phillips screwdriver (one that fits
into screws with an “
✕ ” notch) and the new batteries at hand.
1. Turn on the organizer and enter the Alarm mode.
2. Press INS for six seconds.
3. Press ENTER to confirm that your Organizer is entering
sleep mode.
4. With the Phillips screwdriver, remove the screw to the
battery cover and then remove the lid.
5. Remove the old batteries and quickly replace them with
the new batteries.
6. Press ON for seven seconds to activate the organizer.
7. Replace the battery cover.
Warning! If RESET? appears when you next turn on the
organizer, do not press ENTER unless you want to
reset the organizer and erase all your information.
♦ Keep Written Copies of Important Data
Warning! Information can be lost or corrupted if you make a
mistake while operating this organizer. Therefore, always
keep written copies of your important information in case it is
corrupted or lost.
This unit may change operating modes due to
Electrostatic Discharge. Normal operation of this
unit can be re-established by pressing the reset
key, ON/OFF, or by removing/replacing batteries.