Fisher-Price JEEP LIL WRANGLER 4X4 BARBIE T1961 - Manual (Page 13)

13 T1961pr-0920
4
2
3
1
BATTERY INSTALLATION AND BATTERY RETAINER
(ENGINE COVER) ASSEMBLY
• Lift the hood.
• Place the battery in the battery compartment. Make sure the bat-
tery connector extends toward the motor harness connector.
• Plug the battery connector into the motor harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again. Do not force the
battery connector into the motor harness connector.
Motor Harness
Connector
Battery
Connector
• Fit the battery retainer over the battery, motor harness connector
and battery connector.
• Insert two #8 x 1" screws into the holes in the battery retainer
and tighten.
Battery Retainer
(Engine Cover)
• Lower the hood. Lift the hood latches and fit the short tabs onto
the notches on the hood to secure it.
Hood
Hood
Latches
IMPORTANT! Use only a Power Wheels ® 6 volt (4.0 amp/hr.)
battery. Use of any other battery will damage your vehicle.
Make sure you charge the battery for at least 18 hours using
the Power Wheels
® 6 Volt charger (included) before operating
your vehicle for the first time. Charge the battery for at least 14
hours after each use of the vehicle. Never charge the battery for
more than 30 hours. Failure to follow these instructions could
damage your battery and will void your warranty.
Battery
Motor
Harness
Connector
Battery
Connector