FRIGIDAIRE 137147900 A - Manual (Page 4)

4
C
2
) Attaching dryer (style 1) mounting
hardware
D
2
) Mounting dryer (style 1)
E) Installing or re-installing dryer (style 1)
Use the following instructions for mounting any of these types of 1.
dryers to the pedestal:
Using two or more persons, slightly tip the dryer back and lift it 1.
onto the pedestal. Still tipped, slide the dryer back against the
rear brackets and gently set down the front so the appliance is
between the front and rear brackets.
Attach each front clip to outer-most set of holes with 2 screws. 2.
Insert “A” tab of each rear bracket into the rear slots on rear of 3.
pedestal using rear bracket spacers. Orient bracket inward for
“style 1” dryer mounting.
Adjust the appliance side-to-side to align its mounting holes with 2.
the pedestal’s bracket holes.
Install 2 screws through each rear bracket into the base of the 3.
dryer.
With the pedestal drawer open for better access, install a screw 4.
through each front bracket into the base of the dryer.
Slide appliance/pedestal into place. 1.
Check for levelness and rock all four (4) legs again. Repeat until 2.
level and solid.
Refer to 3. Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
“A”
tab
rear
slot
inward
Install 2 screws through each rear bracket into aligning pedestal 4.
holes.
Dryer cabinet (style 1)
with 3 indents on side.
7.0 cu ft DRYER (STYLE 1) INSTRUCTIONS
NO spacers under front brackets.
- EXCESSIVE WEIGHT HAZARD - To avoid
back or other injury, have more than one person move or lift
the dryer.
SLIDE BACK
TIP DOWN