FEIN Power Tools FMM 250 - Manual (Page 7)

M ULTI M ASTER FMM 250 / M ULTI M ASTER FMM 250 Q
7
EN
Emission values for sound and vibration (Two-figure – specifications as per ISO 4871)
*These values are based on a work cycle
consisting of no-load and full-load opera-
tion of the same duration.
Extension cord
If the use of an extension
cable is required, its length
and conductor cross-section must be ade-
quate for the applicational case, in order to
prevent a voltage drop in the extension cable,
power loss and overheating of the power
tool. Otherwise, the extension cable and
power tool are liable to electrical danger,
and the working efficiency is impaired.
Recommended dimensions of extension
cords at an operating voltage of 120 V – sin-
gle-phase a. c., with only one power tool
FMM 250/FMM 250 Q connected:
Sound emission
Measured A-weighted sound power level
L
wA
(re 1 pW), in decibels: 85
Measuring uncertainty K
wA
, in decibels: 3
A-weighted emission pressure power level
measured at the workplace L
pA
(re 20 µPa),
in decibels: 74
Measuring uncertainty K
pA
, in decibels: 3
REMARK: The sum of the measured emis-
sion value and respective measuring inaccu-
racy represents the upper limit of the
values that can occur during measuring.
Wear ear protection!
Measured values determined in accordance
with the corresponding product standard.
Vibrations
Classification of FEIN
application tools according
to vibration class Weighted
acceleration*
VC0 < 2.5 m/s 2
VC1 < 5 m/s 2
VC2 < 7 m/s 2
VC3 < 10 m/s 2
VC4 < 15 m/s 2
VC5 > 15 m/s 2
WARNING
Cord Size in A.W.G. Wire Sizes in mm 2
18 16 14 0.75 1.5 2.5
Cord Length in Feet Cord Length in Meters
25 100 150 30 60 120
3 41 01 091 21 0.book Seite 7 Dienstag, 24. Juli 2007 3:32 15