FEIN Power Tools FMM 250 - Manual (Page 13)

M ULTI M ASTER FMM 250 / M ULTI M ASTER FMM 250 Q
13
EN
M ULTI M ASTER FMM 250 (Figure 4).
Before mounting or replacing
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
For all work or when chang-
ing application tools, always
wear protective gloves. Danger of injury
from the sharp edges of the application
tools. Application tools can become very
hot while working. Danger of burns!
➤ Unscrew the clamping screw.
➤ Clean the tool holder, the applica-
tion tool and the clamping screw.
➤ Place the application tool exactly
onto the star-shaped tool holder. Pay
attention that the application tool has a
flush fit.
➤ Tighten the clamping screw using
the supplied Allen key.
Attaching/replacing the sanding sheet (Figure 5).
➤ Align the sanding sheet and press it
onto the sanding plate by hand.
➤ Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
provides for good adhesion and pre-
vents premature wear.
The sanding sheet can be pulled off again
and then remounted offset by 120° when
only one tip of the sanding sheet is worn.
WARNING
CAUTION
Clamping screw
Allen key
Tool holder
Fig. 4
Sanding pad
Sanding sheet
Fig. 5
3 41 01 091 21 0.book Seite 13 Dienstag, 24. Juli 2007 3:32 15