Fisher & Paykel DD60 - Manual (Page 33)

31
User maintenance instructions
To replace the filter plate and spray arm
8 Some models only: Before replacing the filter
plate, ensure the O-ring is correctly
positioned on the motor assembly, as shown.
9 Orientate the filter plate and lower it into place:
make sure its kidney-shaped hole aligns with
the matching recess in the DishDrawer base.
10 Ensure the filter plate lies flat in the base, then
lock it into position: turn the outer ring clockwise
until the the marks align with each other and all three pin pairs firmly interlock, as shown.
Important!
The filter plate must not be able to move about freely.
11 Replace the drain filter, ensuring it is flush with the filter plate.
12 Replace the spray arm back onto the impeller.
13 Replace the base rack, lowering its front edge into position first.
14 Plug the DishDrawer back in or turn it on at the power supply.
Note: Where there is broken crockery or glass in the drawer, it must be carefully removed to
prevent damage to the DishDrawer.
O-ring
(some
models
only)
Inter-
locking
pin
Outer ring
Alignment marks
9
10
11
12