Fisher & Paykel DD60 - Manual (Page 31)

29
User maintenance instructions
Important!
Disconnect the DishDrawer® from the power supply and allow all its parts to cool before any cleaning or
maintenance.
Cleaning the surfaces
Important!
We do not recommend the use of the following cleaning aids on your DishDrawer® as they may damage
the surfaces:
Plastic or stainless steel scouring pads Abrasive, solvent, household cleaners
Acid or alkaline cleaners Hand washing liquids or soap
Stainless steel cleaners or polishes Laundry detergents or disinfectants
1 Wipe with a clean damp cloth. Take care not to wet the control panel.
2 Dry with a clean lint-free cloth.
Cleaning the drain filter, spray arm and filter plate
We recommend that the drain filter is cleaned
whenever there is evidence of food particles.
The spray arm may need cleaning about once a month
in normal use or more often should the need arise.
Important !
If a dishwasher cleaner/descaler is used, you must run a wash
programme with detergent immediately afterward to prevent
any damage to your DishDrawer®.
The DishDrawer® must be used with the filter plate, drain filter and spray arm correctly in place.
Cleaning the drain filter
1 Unplug the DishDrawer® or turn it off at the power supply.
2 Lift up the drain filter access panel on the base rack (if fitted).
3 Lift and remove the drain filter. It is normal to find some water under it.
4 Empty, rinse clean under running water and replace back into the allocated space.
5 Ensure the drain filter is flush with the filter plate.
6 Plug the DishDrawer® back in or turn it on at the power supply.
Spray arm
Filter plate Drain filter