Fedders Portable Dehumidifier - Manual (Page 7)

7
Operation
Operating Instructions
Air Conditioner /Cool Mode
1. Install the widow adapter kit and hoses to the unit.
2. Press the On/Off button to turn the unit on. The unit will
power up and display the room temperature.
3. Press the Mode button until the green indicator light shines.
4. Press the Temp/Timer Set buttons to set the desired
temperature. While you are adjusting the setting, the Set
Temperature indicator will shine and the display will show
the set temperature. After you have finished adjusting the
temperature, the display will default back to the room
temperature and the “Room Temp” indicator will shine.
5. Press the Fan Speed button to select the desired setting
(High, Med, Low). The fan speed indicator light will shine
for the selected speed.
6. Condensed water may accumulate in the unit. If the internal
tank becomes full, the warning light will shine and the unit
will not operate until the unit has been drained. See
Draining Excess Water section for instructions on how to
drain the water.
7. Once the room reaches the set temperature, the compressor
will turn off and the fan will continue to operate.
Dehumidify Mode
1. Press the On/Off button to turn the unit on. The unit will
power up and display the room temperature.
2. Press the Mode button until the orange indicator light
shines above the word Dehumidify.
3. Condensed water may accumulate in the unit. If the
internal tank becomes full, the warning light will shine
and the unit will not operate until the unit has been
drained. See Draining Excess Water section.
4. The fan will operate in Med speed. Fan speed is not
adjustable in Dehumidify mode.
Fan Mode
1. Press the On/Off button to turn the unit on. The unit will
power up and display the room temperature.
2. Press the Mode button until the yellow indicator light
shines.
3. Press the Fan Speed button to select the desired setting
(High, Med, Low). The fan speed indicator light will shine
for the selected speed.
4. The unit will operate continuously in Fan mode.
Timer
The timer can be set to turn the unit off or on. The timer is
adjustable between 1 and 12 hours.
To turn unit off automatically:
1. With unit running in desired mode, press timer button.
2. Use Temp/Timer Set buttons to select number of hours
you would like the unit to run until it automatically
shuts off. After you have finished adjusting the timer,
the display will default back to the room temperature
and the “Room Temp” indicator will shine. Timer
indicator will blink when set. To turn timer off press the
timer button.
To turn unit on automatically:
1. With unit powered on select desired mode and fan
speed, then power unit off.
2. With machine powered off, press timer button to select
number of hours until you would like the unit to
automatically start running in air conditioning mode.
Timer indicator will blink when set. The display will
show the number of hours the unit is set until it begins
operation. To turn timer off press the timer button.
Before starting this unit
1. Select a suitable location, making sure you have a level surface with no obstructions, and easy access to an electrical outlet.
2. Install the window adapter kit, as described in the Installation section.
Note: The window adapter kit is required only while using the Cool mode.
3. Plug the unit into a grounded electrical outlet. Do not use an extension cord.