Furuno FR-2805 Series User Manual
Marine radar, Far/fr-2805 series
This manual is related to the following products:
Table of contents
Document Outline
- SAFETY INSTRUCTIONS
- TABLE OF CONTENTS
- INTRODUCTION
- 1. OPERATION
- 1.1 Turning on the Power
- 1.2 Transmitter ON
- 1.3 Controls
- 1.4 CRT Brilliance
- 1.5 Tuning the Receiver
- 1.6 On-screen Legends and Markers
- 1.7 Degaussing the CRT Screen
- 1.8 Initializing the Gyro Readout
- 1.9 Presentation Modes
- 1.10 Selecting the Range Scale
- 1.11 Selecting the Pulsewidth
- 1.12 Adjusting the Sensitivity
- 1.13 Suppressing Sea Clutter
- 1.14 Suppressing Precipitation Clutter
- 1.15 Interference Rejector
- 1.16 Measuring the Range
- 1.17 Measuring the Bearing
- 1.18 Collision Assessment by Offset EBL
- 1.19 Measuring Range and Bearing Between Two Targets
- 1.20 Setting a Guard Zone (Guard Alarm)
- 1.21 Off-Centering
- 1.22 Echo Stretch
- 1.23 Echo Averaging
- 1.24 Electronic Plotting Aid (EPA)
- 1.25 Target Trails (Echo Trails)
- 1.26 Parallel Index Lines
- 1.27 Anchor Watch
- 1.28 Origin Mark
- 1.29 Zoom
- 1.30 Markers
- 1.31 Menu Keys
- 1.32 RADAR 1 and 2 Menu Settings
- 1.33 Function Keys
- 1.34 EPA Menu
- 1.35 NAV INFORMATION Menu and Navigation Data Display
- 1.36 Radar Map
- 1.37 Suppressing Second-trace Echoes
- 1.38 Adjusting Relative Brilliance Levels of Screen Data
- 1.39 Set and Drift (Set and Rate)
- 1.40 Display of Ancillary Information
- 1.41 Alarms
- 2. OPERATION OF ARPA
- 2.1 General
- 2.2 Keys Used for ARPA
- 2.3 ARPA Menu Operation
- 2.4 Start-up Procedure
- 2.5 Automatic Acquisition
- 2.6 Manual Acquisition
- 2.7 Changing Plot Symbol Size
- 2.8 Adjusting Brilliance of Plot Marks
- 2.9 Displaying Target Data
- 2.10 Mode and Length of Vectors
- 2.11 Past Position Display
- 2.12 Setting CPA/TCPA Alarm Ranges
- 2.13 Setting a Guard Zone
- 2.14 Operational Warnings
- 2.15 Trial Maneuver
- 2.16 ARPA Track Test
- 2.17 Criteria for Selecting Targets for Tracking
- 2.18 Factors Affecting ARPA Functions
- 3. RADAR OBSERVATION
- 4. MAINTENANCE
- 5. TROUBLESHOOTING
- APPENDIX
- MENU TREE
- MECHANICAL PARTS LISTS
- ELECTRICAL PARTS LISTS
- OUTLINE DRAWINGS
- Declaration of conformity to type
- Declaration of conformity (FR/FAR-2855, FR/FAR-2855W, FR/FAR-2865SW)