Jacking up and towing – FIAT SPIDER 2000 User Manual

Page 24

To Fit the Wheel

— Fit the spare wheel seeing that the

location dowel fits into the location
hole in wheel disk.

— Refit trim and refit and tighten

uniformly the wheel fixing bolts in

criss-cross sequence.

— Remove the jack hand lever and

actuate handwheel F of extension

E and lower the car.

— Fully tighten the wheel bolts in

criss-cross sequence.

— Check that the newly fitted tire is

inflated to the correct pressure.

When repositioning the jack in the

trunk make sure extension E is properly

housed and Jack, bag and hand lever D

are correctly fastened by strap B.

JACKING UP AND

TOWING

When either the front or rear end

of car must be raised with a garage

jack, it is necessary to fit jack head

under front suspension cross rail, in-

terposing a suitably thick (abt. 3 cm

- I'A in.) wooden block, or rear

axle bulge.

If car needs towing with a rope

this must be attached to the spe-

cially provided front brackets.

34975