Test core/net 1, Install software on core/net 0 – Meridian Audio M3900 User Manual
Page 148

Page 148 of 174
Appendix A: Flash Download procedure
553-3001-216 Standard
5.00
January 2002
Test Core/Net 1
1
Test Call Processing. This includes, but is not limited to the following:
a.
Check for dial tone.
b.
Make internal, external, and network calls.
c.
Check attendant console activity.
d.
Check DID trunks.
e.
Check any auxiliary processors.
Note: From this point forward you will be upgrading Core/Net 0.
Install software on Core/Net 0
1
Move the CPSI port cable from J25 on Core/Net 1 to J25 on Core/Net 0.
2
Set the IODU/C faceplate switch to ENB.
3
Place the CP Install disk that corresponds with the installed CP card type
into the IODU/C in Core/Net 0.
a.
Press the button on the CD-ROM drive to open the CD-ROM disk
holder.
b.
Place the CD-ROM disk into the holder with the disk label showing.
c.
Use the four tabs to secure the CD-ROM drive.
d.
Press the button again to close the CD-ROM disk holder (do not
push the holder in by hand).
4
Press the MAN RST button on the CP card in Core/Net 0 to reboot the
system and start the Software Installation Tool. (The terminal displays
SYSLOAD messages during file loading. When SYSLOAD is
completed, the NT logo appears.)
5
When the NT logo appears, press
6
When the Main Menu appears, select the followingoptions in sequence:
to Install menu