Fluke Ti20 - Manual (Page 47)

Advanced Imager Operation
Adjusting Sleep Mode
3
3-9
Adjusting Sleep Mode
Sleep mode is used to conserve battery life if the Imager is turned on but not being used.
If you turn Sleep mode
OFF
, the Imager will run until the battery is depleted. If Sleep
mode is enabled, the Imager will automatically power down after the specified time
period.The default Sleep mode time period is 15 minutes.
1. From the Home display, press G (
MENU
) four times to navigate to the Adjust
Alarm and Sleep Mode display.
2. Press H (
SLEEP
) to access the Sleep Mode Adjust display
3. Press F (4) to move the choice box left or H (5) to move the choice box
right. Options are 5, 15, 30, 60 minutes or
OFF
.
dag127f.bmp
4. Press G (
DONE
) to return to the Home display.