Basic operations 6, Preparation of power supply – Fostex FM-3 User Manual
Page 6
Basic operations
6
Preparation of power supply
To operate the unit on internal battery power, set AA alka-
line or nickel hydride batteries to the supplied battery box
and fit the box to the battery compartment on the right side
panel.
Optional AC adaptor or
external battery
V to 24 V. When you connect an external power source to
the [DC IN] connector, use the appropriate power source that
matches the rated voltage of the [DC IN] connector.
For the detail information on the pin assignment of the [DC IN]
connector, see page 12 of “Features and controls”.
To operate the unit on external power, connect the
optional dedicated AC adaptor or an external battery to
the [DC-IN] connector on the left side panel.
Make sure to set alkaline or nickel hydride batteries to the
battery box in correct direction as marked on the box. Set
four batteries on each side of the battery box.
hydride batteries of the same model and same capacity.
correct direction by matching the symbol on the battery box to the
symbol on the panel of the unit.
Symbol
Battery box
hydride) to be used from the meter display. By default, it is
set for alkaline batteries. If you use nickel hydride batteries,
change the battery type setting (see page 20).
Battery box compartment
ies currently used, the EMPTY indicator, battery indicator
and alert display do not work correctly.
Battery box compartment
box, slide down the [EJECT/LOCK]
lever to unlock the battery box.
The battery box is slid to the front a
few millimeters and you can pull it
out by hand.
power or set the [POWER] switch to the “EXT position.
After fully inserting the battery box, slide
up the [EJECT/LOCK] lever to the
LOCK position.
A tab appears as shown on the right
figure and the battery box is locked.
Battery box
Tab