Fostex FM-3 User Manual
Page 18
18
LIMITER parameter setting
By setting the [LIMITER] switch to “ON” (or “LINK”), the lim-
iter function is enabled and you can apply the limiter to the
stereo L/R buss.
The threshold level and ratio (compression ratio) of the lim-
iter are set to “+12” and “5.1” respectively by default.
(1)
While the output status display is shown, press the
[EDIT] key long enough.
“
”, the current THRE value, starts flashing quickly.
You can now edit the threshold level.
[LIMITER] switch on the front panel is set to “ON” and the input
status display looks as below.
(2)
By pressing the [EDIT] key, you can alternately
flash the THRE (“
”) and RATIO (“
”) values.
To edit the threshold level, flash the THRE value (“
”).
To edit the ratio, flash the RATIO value (“
”).
(3)
While the THRE value (“
”) or the RATIO (“
”)
is flashing, use the [+] or [-] key to select the desired
value.
You can select the THRE value between “
” and “
”,
while you can select the RATIO value between “
” and
“
”.
Flashing
(4)
After selecting the desired value, press the [EDIT]
long enough to stop flashing.
(5)
Press the [EDIT] key to exit the status display mode.
To select the threshold value:
To select the ratio:
Press the [-] key
Press the [+] key
Press the [-] key
Press the [+] key
even after you turn off the unit. If you initialize the flash
memory using the system status display, it is reset to
the default setting.
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing