Controls and features – FORD 1998 Expedition User Manual
Page 67
3. Within five seconds of turning the ignition to OFF, insert the second
previously programmed SecuriLock
key into the ignition and turn the
ignition from OFF to RUN (maintain ignition in RUN for at least one
second but no more than 5 seconds).
4. Turn the ignition to OFF and remove the second SecuriLock
key
from the ignition.
5. Within 10 seconds of turning the ignition to OFF, insert the
unprogrammed SecuriLock
key (new key/valet key) into the ignition
and turn the ignition from OFF to RUN (maintain ignition in RUN for at
least one second). This step will program your new SecuriLock
key.
6. To program additional SecuriLock
key(s), repeat this procedure from
step 1.
If the programming procedure was successful, the new SecuriLock
key(s) will start the vehicle’s engine. The theft indicator (located on the
instrument panel) will light for three seconds and then go out.
If the programming procedure was not successful, the new SecuriLock
key(s) will not operate the vehicle’s engine. The theft indicator will flash
on and off. Wait at least one minute and then repeat the procedure from
step 1. If failure repeats, bring your vehicle to your dealership to have
the spare SecuriLock
key(s) programmed.
REMOTE ENTRY SYSTEM
Your vehicle is equipped with a remote entry system which allows you to:
• unlock the vehicle doors without a key.
• lock all the vehicle doors without a key
• activate the personal alarm.
The remote entry features only operate with the ignition in the OFF
position.
Controls and features
67