FORD 1998 Expedition - Manual (Page 66)

Theft indicator
The theft indicator on top of the instrument panel will operate as
follows:
• When the ignition is OFF, the theft indicator will flash briefly every 2
seconds to indicate the SecuriLock
௢ system is protecting your
vehicle.
• When the ignition is turned to ON or START, the theft indicator will
light for 3 seconds and then go out. If the theft indicator stays on for
an extended period of time or flashes rapidly, have the system
serviced by your dealership or a qualified technician.
Programming spare SecuriLock ி keys
Spare SecuriLock
௢ keys can be purchased from your dealership and
programmed to your SecuriLock
௢ anti-theft system (up to a total of 8
keys). Your dealership can program your new SecuriLock
௢ key(s) to
your vehicle or you can do it yourself using the following simple
procedure. To program a new SecuriLock
௢ key yourself, you will need
two previously programmed SecuriLock
௢ keys (keys that already
operate your vehicle’s engine). If two previously programmed
SecuriLock
௢ keys are not available (one or both of your original keys
were lost or stolen), you must bring your vehicle to your dealership to
have the spare SecuriLock
௢ key(s) programmed.
Procedure to program spare SecuriLock
ி
keys to your vehicle
New SecuriLock
௢ keys must have the correct mechanical key cut for
your vehicle.
Conventional (non-SecuriLock
௢) keys cannot be programmed to your
vehicle.
You will need to have two previously programmed SecuriLock
௢ keys and
the new unprogrammed SecuriLock
௢ key readily accessible for timely
implementation of each step in the procedure. Please read and
understand the entire procedure before you begin.
1. Insert the first previously programmed SecuriLock
௢ key into the
ignition and turn the ignition from OFF to RUN (maintain ignition in
RUN for at least one second).
2. Turn ignition to OFF and remove the first SecuriLock
௢ key from the
ignition.
Controls and features
66