FUNAI 6842PE - Manual (Page 11)

11
OPERA
TING
THE PLASMA DISPLA
Y
POWER
INPUT SELECT
DISPLAY
VOL
MUTE
SCREEN MODE
STILL
STILL
STILL
You can freeze the image displayed on the
screen.
1 Press the STILL button.
The still mode turns on, and the image dis-
played on the screen is frozen.
NOTE:
• When the still mode is on, the message "Still"
slowly flashes on the screen.
• When the still mode is on, the audio is muted.
• You cannot turn the still mode on when there is no
video signal or when switching between video sig-
nals.
2
Press the STILL button again to turn the still
mode off.
NOTE:
• You can also press the INPUT SELECT,
DISPLAY, SLEEP, VOL K(up) / L(down), MUTE,
SCREEN MODE or MENU buttons to turn the still
mode off.
INPUT SELECT
DISPLAY
MENU PREVIOUS
SLEEP
SLEEP
SLEEP
You can select the sleep timer.
1 Press the SLEEP button.
The sleep timer is displayed on the screen.
NOTE:
• If the sleep timer is activated, the remaining time
is displayed on the screen.
If not activated, “0 minutes” is displayed.
2
Press the SLEEP button to set the time.
The SLEEP button switches between the
times.
The timer starts counting down after the mes-
sage displaying the set time disappears (after
approximately 4 seconds).
NOTE:
• The remaining time displayed for the sleep timer
changes in steps of 1 minute.
• To change the set time, repeat the above proce-
dure.
0 minutes 10 minutes 90 minutes
L0601(EN)v1.qx3 04.8.10 3:08 PM Page 11