Hitachi KP-E500 - Manual (Page 8)

The camera setting and adjustments can be changed to conform to conditions of use. Use the setting menu indicated on the monitor
screen to check and change the settings and adjustments. The setting menu is comprised as follows.
Camera mounting
If the camera is to be suspended from the ceiling,
change the position of the tripod adaptor from the
bottom to the top of the camera, as indicated in the figure.
Caution:
Use the following type of camera mounting screw.
Type :U 1/4-20
Length:L=7mm
If longer than 7 mm, there is risk of internal damage to
the camera. Conversely, if too short, the camera will not
be firmly secured and there is risk of dropping.
Tripod adaptor
Binding head screws M3 x 8
Setting menu description
Setting menu composition
Main Menu
(page 13 )
・ Display character setting
・ Display position setting
・ WB mode setting
・ WB detection area setting
・ Manual R/B gain adjustments, etc
・ Gamma
・ Chroma gain adjustment
・ Black reference level adjustment
・ Detail adjustment
・ Polarity
・ Digital noise reduction
・ Burst signal
・ Camera reset
Camera Title Menu (page 14 )
Light Control Menu (page 16 )
White Balance Menu (page 25 ) (*)
Sub Menu (page 29 )
・ Light control mode setting
・ Video level adjustment, etc.
AGC Menu (page 19 )
Shutter Speed setting (page 21 )
Sensitivity enhance setting (page 22)
Color-B/W selection (page 23 ) (*)
11
12
・ AGC mode setting
・ Fixed and limit gain setting
(*) Note: Only KP-DE500