Hague Quality Water Intl WATERMAX 60 SERIES - Manual (Page 16)

WaterMax 60 Series Owner’s Manual 11/10/2008 16
Service Settings, Cont.
Display Meaning Possible Values Comments
Total
Regens 00000 Total number of regenerations since
Service Settings was last entered Cannot be reset
00000–99999
Total
Gallons
00000000
Total amount of water that has
passed through the appliance since
Service Settings was last entered Cannot be reset
00000000–99999999
Mode 1
Frequency Operating (Regeneration) Mode Mode 1
Frequency
Mode 1
Days of the Week
Mode 2
Demand Delayed
Mode 3
Demand
See Operating Modes
section that follows
Days
Between Regenerations 01 Number of days between
regenerations 00 to 12 Displays only when in
Mode 1
Frequency
Regen
Days SMTWTFS
YYYYYYYY
Select which days to regenerate Various combinations or Y’s
and blank spaces Displays only when in
Mode 1
Days of the Week
Hardness
Grains
040
Hardness of the water that was
tested 003 to 999 Grains
(00000 to 99999 mg/L) This is the actual hardness
reading and is not
compensated for iron
Iron
ppm
00
Amount of iron in parts per million of
the water that was tested 00 to 99 ppm (mg/L) This value is used to
calculate compensated
hardness automatically
Manganese
ppm
00
Amount of manganese in parts per
million of incoming water 00 to 99 ppm (mg/L) This value is used to
calculate compensated
hardness automatically
Salt Type
Sodium Regenerant filling the brine tank Sodium
Potassium
Compensated
Hardness
00040
Compensated hardness using the
hardness, iron, and manganese
settings Cannot be set
ppm or (mg/L) The formula used is:
Hardness + (4 x each ppm
iron) + (4 x each ppm
manganese) =
compensated hardness
Capacity
Grains
28730
The desired capacity number 00000 to 99999 Grains
(0000 to 9999 gm)